The primary objective of this student group project I took part in with Mr. Marat Khairtdinov was to optimise the shape of a drone chassis by strict material volume constraints through computational topology optimisation. The initial chassis geometry was modelled in Rhino as an assembly of fundamental primitives. The design consisted primarily of a cuboid with 4 cylinders at the corners to carry the propellers and a smaller cuboid attached to the bottom of it to contain the controllers, sensors and battery.
The base model was imported into Ansys along the ZX plane and configured as a Static Structural item. To accurately simulate aerospace-grade structural performance, the composite material Epoxy Carbon UD was assigned to all geometric entities prior to meshing with an element size of 1 cm. Boundary conditions were defined to replicate hovering flight stresses, applying an upward pressure force of -5 KPa to each of the four corner cylinders to simulate aerodynamic lift, alongside a fixed support established on the bottom face of the electronics enclosure. Prior to the solver execution, the optimisation region was explicitly restricted to the primary chassis box, intentionally excluding the propeller cylinders and the lower electronics box from the design space. The optimisation objective was set to minimise compliance, governed by a strict response constraint of 5%, and the solver was run to compute the most efficient material distribution across the defined region.
The raw topological data output by the solver required further geometric post-processing within SpaceClaim. Shape optimisation for the four propeller mounts and the base enclosure was suppressed, and redundant zero-load protrusions were eliminated utilising the Shrinkwrap function. To safely accommodate the optimised material pathways, specific dimensional adjustments were introduced to the model by increasing the axial radius and vertical height of the four load-bearing cylinders to 2 mm, while the thickness of the central base box was increased symmetrically by 2 mm on both the upper and lower surfaces. Additionally, voids occurring within the four primary structural axes connecting the propellers to the base were filled. The modified facets were then merged and converted into a solid model, which was in turn exported to Rhino and imported into DesignModeler to finalise the geometric reconstruction.
The reconstructed model was subjected to a secondary static structural analysis to validate the equivalent stress and total deformation of the newly generated topology. Following a successful structural validation, the exported .3dm file was opened in Rhino, whereby the polysurface was converted into a mesh. A custom Grasshopper script was utilised to systematically smooth the mesh surface, eliminating rough and jagged analytical artefacts generated during the volume reduction process. The smoothed mesh was subsequently baked back into the Rhino environment, converted into a closed solid polysurface via the MeshtoNURB command, and successfully exported as an STL file for downstream additive manufacturing.
Related Tools & Supplementary Materials
- Rhino
- Grasshopper
- Ansys
- Supplementary Materials: Topology optimisation assignment report (PDF), ANSYS and Rhino files
1 - Initial ChassisRhino primitives
Figure 1: The initial model of the drone in Rhino before exporting it to Ansys for topology optimisation.
2 - Static Structural AnalysisMesh, lift, and the design space
Figure 2: The optimisation region specified in Ansys for topology optimisation.
3 - Geometric ReconstructionSpaceClaim and DesignModeler
Figure 5: The optimised topology after removing redundant protrusions, filling voids and accommodating excess material in SpaceClaim.
4 - Validation and Manufacturing ModelStress check, smoothing, and STL
Figure 7: Total deformation of the final optimised shape in Ansys.